Chalupa102
02-25-2010, 08:38 PM
I want to install a kill switch for red lights. When i turn the switch off, i want the engine to turn off and when i turn the switch back on, i want the power to return to everything so i can use the my push button i installed to re-start the engine when the light turns green. Kind of like turning the key off and back on before you re-start it.
I have been looking more into the schematics and found out what pin does what. Pin 2 (IG1) controls DRL, alternator, turn signals, interior light, wipers, radiator fan, A/T, c/c, and combination meter. Pin 6 (IG2) controls igniters/coils, alternator, fuel injectors, A/T, c/c, and combination meter.
With this, it looks like when power is cut to pin 6 (IG2) the engine turns off.
Can i wire a switch to do the same thing turning the key does (shutting off the engine) like in the pic below?
http://i115.photobucket.com/albums/n286/Chalupa102/addedswitch.jpg
I have been looking more into the schematics and found out what pin does what. Pin 2 (IG1) controls DRL, alternator, turn signals, interior light, wipers, radiator fan, A/T, c/c, and combination meter. Pin 6 (IG2) controls igniters/coils, alternator, fuel injectors, A/T, c/c, and combination meter.
With this, it looks like when power is cut to pin 6 (IG2) the engine turns off.
Can i wire a switch to do the same thing turning the key does (shutting off the engine) like in the pic below?
http://i115.photobucket.com/albums/n286/Chalupa102/addedswitch.jpg
